5
Manufacturer (see Operating instructions)
0810 / 9000 422 089
Alignment
High levels of noise, intense vibrations and “wandering” may occur due to incorrect
alignment.
Aligning the washing machine with a spirit level.
1.
Undo the lock nut in a clockwise direction using a wrench.
2.
Adjust the height by tuning the appliance foot.
All four appliance feet must be placed firmly on the floor.
The washing machine must not be able to wobble.
Check the alignment of the washing machine with a spirit level
and correct if necessary.
3.
Tighten the lock nut against the housing.
The lock nuts on all four appliance feet must be screwed tightly against
the housing.
Electrical connection
ʑ
Connect the washing machine to an alternating current and using only a properly installed
and grounded socket.
ʑ
The mains voltage and specifications on the washing machine must match
a
page 6:
Technical specifications.
ʑ
For information about the connected load and required fuse
a
page 6:
Technical
specifications.
ʑ
Ensure that:
– the main plug fits into the socket outlet,
– the cable cross-section is adequate,
– the earthing system has been installed correctly.
ʑ
A damaged power cord may be replaced by an electrician only.
A replacement power cord is available from customer service.
ʑ
Do not use multiple plugs/connectors or extension cables.
ʑ
If a residual current operated circuit-breaker is used, use only a type which features this
symbol
:
Only this symbol guarantees compliance with the currently valid regulations.
ʑ
Mains plug:
– do not insert into/pull out of the socket with damp hands.
– do not pull the plug out of the socket by pulling on the power cord.
– never pull out the plug while the appliance is in operation.
6
Transportation, e.g. if moving house
Before transporting the washing machine:
1.
Turn off the tap/water supply.
2.
Release the water pressure in the supply hose.
a
Operating instructions, page 11: Filter in the water inlet hose
.
3.
Drain any residual detergent solution.
a
Operating instructions, page 11: Drain pump
.
4.
Disconnect the washing machine from the power supply.
5.
Remove the hoses.
Installing transport bolts:
1.
Remove the covers.
2.
Insert all 4 spacer. Clamp the
power cord into the holders.
Insert and tighten the screws.
The transport bolts
must
be removed after transportation.
a
page 3
.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and start the
Drain
or
Spin
programme.
Technical specifications
ʑ
Dimensions (width x depth x height)
60 x 44 x 84.2 cm
ʑ
Weight
64.5 kg
ʑ
Power supply
Nominal voltage 220-240 V, 50 Hz
Nominal current 10 A
Nominal power 2300 W
ʑ
Water pressure
100-1000 kPa (1-10 bar)
ʑ
Test programmes
According to currently valid European Standard
60456
1.
2.
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
