Cleaning and maintenance
en
23
The drain hose at the siphon
is blocked
1.
Switch off the appliance. Pull out the
mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose, residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Reattach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply
blocked
:
Warning
Risk of electric shock!
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme (except
Rinse/Spin/Empty).
3.
Select
Start
/Pause. Allow the
programme to run for approximately
40 seconds.
4.
Turn the programme selector to
Off
.
Pull out the mains plug.
5.
Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
6.
For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
7.
Connect the hose and check for
leaks.