Basic operation
en
31
13.8 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press
Start/Reload
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: End.
13.9 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡
The programme is set.
→
"Setting a programme", Page 29
¡
The "Ready in" time is set and ac-
tivated.
→
1.
Press
Start/Reload
.
The activated "Ready in" time is
paused.
2.
Press
Ready In
repeatedly until the
display indicates the desired
"Ready in" time.
3.
Press
Start/Reload
.
The changed "Ready in" time is ac-
tivated.
13.10 Adding laundry
1.
Press
Start/Reload
.
The appliance pauses.
Note:
If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Start/Reload
.
13.11 Cancelling the pro-
gramme
1.
Press
Start/Reload
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
– If the water level is high, start
the
Spin
programme or select a
suitable programme for draining.
→
3.
13.12 Unloading the laundry
1.
Open the appliance door.
2.
Remove the laundry.
13.13 Switching off the appli-
ance
1.
Turn the programme selector to
Off
.
2.
Turn off the tap.