en
Operating the appliance
26
Start the programme
Press the
Ü
button. The indicator lamp
lights up and the programme starts.
The display panel shows the "Ready in"
time while the programme is running or
the programme length and the
programme progress symbols when the
washing programme has started.
Note:
Foam detection
If the
o
symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
activated additional rinse cycles to
remove the foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Child lock
(
w
3 sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock.
To
activate/deactivate
, press and hold
the
Finish in
5
-
and
+
buttons at the
same time for approx. three seconds.
The
w
symbol is appears in the
display panel.
■
w
lights up: The childproof lock is
active.
■
w
flashes briefly: The childproof
lock is active and the programme
selector was turned or a button was
pressed.
Note:
The childproof lock remains
active, even once the washing machine
has been switched off. Before selecting
the next programme, deactivate the
childproof lock.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
Press the
Ü
button to do this.
The
Ü
button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel:
■
Both
the - P - and
Ï
symbols light
up, it is possible to add laundry.
■
- P - lights up, it is not possible to
add laundry.
To continue the programme, press the
Ü
button. The programme continues
automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
■
The load display is not active during
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Press the
Ü
button.
2.
Select another programme.
3.
Press the
Ü
button. The new
programme starts from the
beginning.