Operating the appliance
en
25
1.
Pull out the detergent drawer as far
as possible.
2.
Add detergent and/or care products.
3.
Close the detergent drawer.
Measuring aid* for liquid detergent
*depending on the model
Position the measuring aid for dosing
the correct amount of liquid detergent:
1.
Pull out the detergent drawer. Press
down the insert and fully remove the
drawer.
2.
Slide the measuring aid forwards,
fold it down and click it into place.
3.
Reinsert the drawer.
Note:
Do not use the measuring aid for
gel detergents and washing powder, or
for programmes with prewash or when
the “Ready in” time is selected.
For models without a measuring aid
,
pour the liquid detergent into the
appropriate dispenser and place it in
the drum.
Change the programme
default settings
You can use or change the default
settings for this washing cycle.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Note:
Pressing and holding the button
automatically runs through the set
values to the end. Then press the button
once more and you can then change
the setting values again.
The settings are activated without
needing to be confirmed.
The settings are not saved after
switching off the washing machine.
Default programme settings
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The button indicator lamps light up if a
setting is activated.
The settings are not saved after
switching off the washing machine.
Additional programme settings
Measuring aid
A
For liquid detergent
Compartment
II
Detergent for the main
wash, water softener,
bleach, stain remover
Compartment
i
Fabric softener, liquid
starch;
do not exceed
max.
Compartment
I
Detergent for prewash