en
Positioning and connecting
46
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
.
(from
■
Never use a damaged machine.
Inform customer services.
Preparatory work:
1.
Check the machine.
2.
Remove the protective film from the
control panel.
3.
Connect the mains plug.
4.
Turn on the tap.
Run the programme without laundry:
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
Drum Clean
90 °C
programme.
4.
Open the detergent drawer.
5.
Pour approximately 1 litre of water
into compartment
II
.
6.
Pour standard detergent into
compartment
II
.
Note:
To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for woollens or delicates.
7.
Close the detergent drawer.
8.
Press the
Ü
button.
9.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
E.g. when moving house
Preparatory work:
1.
Turn off the tap.
2.
Reduce the water pressure in the
and maintenance – filter in the water
supply blocked
3.
Disconnect the washing machine
from the mains.
4.
Drain the remaining water:
maintenance – the drain pump is
blocked, emergency draining
5.
Remove the hoses.
Installing the transport braces:
1.
Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2.
Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.