33
4.
Take the drainage hose out of the holder. Remove the
sealing cap, drain water into a suitable receptacle.
Press on sealing cap and insert drainage hose into the
holder.
Note:
Residual water may run out.
5.
Carefully unscrew the pump cover. Clean the interior, pump
cover thread and pump housing (fan impeller in the
detergent-solution pump must rotate).
6.
Reinsert and screw on pump cover. Handle should be
vertical.
7.
Insert service flap (1), engage (2) and close (3).
²
To prevent unused detergent from flowing into the outlet during
the next wash cycle: Pour approx. 1 litre of water into dispenser
II
and start the
Drain
programme.
Drainage hose on the siphon blocked
1.
Switch off the appliance. Pull out the mains plug!
Note:
Residual water may run out!
2.
Loosen hose clip, carefully remove drainage hose.
3.
Clean drainage hose and siphon spigot.
4.
Re-attach drainage hose and secure connection point with
hose clip.
www.devicemanuals.eu/
Insert service flap (1), engage (2) and close (3).
Insert service flap (1), engage (2) and close (3).
To prevent unused detergent from flowing into the outlet during
To prevent unused detergent from flowing into the outlet during
the next wash cycle: Pour approx. 1 litre of water into dispenser
the next wash cycle: Pour approx. 1 litre of water into dispenser
and start the
and start the
www.devicemanuals.eu/
Drain
Drain
Drainage hose on the siphon blocked
Drainage hose on the siphon blocked
