Set up and connectNL
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
2.
To adjust the appliance, turn the
appliance feet. Check the horizontal
adjustment of the appliance with a
spirit level.
washbasin
the water drainage
feeding hose with
a bend
fixate and
gene.
plastic stand
pipe with rubber
run muff or a
floor drain
the water drainage
feeding hose with
a bend
fixate and
gene.
All appliance feet must be firmly
planted on the floor.
3.
Tighten the lock nuts against the
housing with an open-end wrench
SW17 hand-tight.
4.7 Adjusting the device
To reduce noises and vibrations and to
prevent the device from walking, place
the device horizontally.
1.
Loosen the lock nuts with a SW17
open-end wrench.
Hold the appliance foot while
doing so and do not adjust the
height.
4.8 Connecting the appliance
electrically
Remark:Your home electrical
installation for this appliance must
comply with local legal and safety
regulations and must include an
earth leakage circuit breaker.
17
Summary of Contents for WM16XK75NL
Page 63: ......