Troubleshooting NL
Malfunction
Program does not start.
Cause and Troubleshooting
1.
Open the door again.
2.
Remove trapped laundry.
3.
Close the door.
4.
To start the program, press Start/Refill
.
The detergent drawer is not closed as far as it will go.
▶
Push the detergent drawer into the appliance as far as it
will go.
Pump of the intelligent dosing system is blocked.
1.
Switch off the device.
2.
Clean the pump unit.
"Cleaning the detergent drawer",
3.
If the indication reappears, enable the service.
Remark: You can start the washing program if you
deactivate the intelligent dosing system and dose
manually.
Door cannot be
opened.
is activated.
▶
Resume the program by Centrifuge or Drain to
choose and press Start/Refill
at
to press.
"Resume program at rinse hold", page 34
Temperature is too high.
▶
Wait for the temperature to drop.
▶
Water level is too high.
▶
Select a suitable program for draining.
Power cut.
▶
Open the door with the emergency release.
Washing water is not
pumped out.
Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
51