NL Troubleshooting
Malfunction
Cause and Troubleshooting
Drum is spinning, er
no water flows into
the appliance.
Load recognition is active.
▶
No error, no action necessary.
Remark: The load detection can take up to 2 minutes.
strong foam
ming.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric
softener with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
▶
When the intelligent dosing is activated, reduce the
basic dosing amount
▶
When dosing manually, reduce the amount of
detergent for the next wash with an equal load.
i-Dos i-Dos
not be pressed
can
Intelligent dosing is not possible for this program.
▶
No error - no action required.
Program progress does not allow intelligent dosing. No
solution possible.
High spin speed
rental is not
reached.
Low spin speed is set.
▶
Set a higher spin speed for the next wash.
Anti wrinkle is activated.
▶
Select a suitable program for the type of fabric.
Unbalance control system compensates for
imbalance through reduced spin speed.
▶
Redistribute the laundry in the drum.
Remark: If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
▶
Start the program Centrifuge.
Program centrifugal
run does not start.
Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶
Make sure that the drain pipe and the water
drain hose are not kinked or pinched.
54