Service NL
s When you use the intelligent dosing
activates or deactivates the
system, the setting is saved.
2.
Fill with detergent.
3.
If desired, fill with a care product.
13.4 Filling the drum with
laundry
4.
Slide the detergent drawer into the
appliance.
Remark: To avoid creasing, keep the
maximum load of the
13.6 Starting the program
Remark: If you want to change the
time until the program end, first set
the ready in time.
Required: The laundry is prepared.
1.
Open the door.
▶
on Start/Refill
to press.
Make sure the drum is empty.
a The drum rotates and a
load recognition takes place, which
can take up to 2 minutes, after
which the water flows into the
device.
a The display shows whether the program
maduur or the ready in time
displayed.
a After the program end, it shows
display: -0-.
2.
Place the laundry in the drum.
3.
Close the door.
Make sure that no small items of
laundry are caught in the door.
13.5 Dosing detergent and care
agent
13.7 Soaking laundry
In programs where intelligent dosing
is not possible or desired, you can
dose the detergent manually.
Remark: No additional detergent is
needed. The soapy water is then used
for washing.
1.
Start the program.
Tip: In addition to the intelligent
dosing, you can also add other
detergents such as stain remover,
starch or bleach to the manual dosing
compartment. Do not add additional
detergent to the manual dosing
compartment to avoid overdosing or
foaming.
2.
To pause the program, after about
10 minutes, press Start/ Refill
.
3.
To resume the program after the
desired soaking time, pressStart/
Refill
.
13.8 Adding laundry
1.
Press Start/Refill
.
The device pauses.
Remark: Keep the directions for
1.
Pull out the detergent drawer.
33
