Intelligent dosing system
en
35
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→
"Cleaning the detergent drawer",
If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers →
.
1.
Pull out the detergent drawer.
2.
Open the dispenser cover.
3.
Pour liquid detergent
and fabric
softener into the relevant dis-
pensers.
→
Do not exceed the marking for the
maximum filling level when filling.
4.
Close the dispenser cover.
Note:
To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
5.
If required, add cleaning aids such
as stain remover, water softener or
bleach into the compartment for
manual dosing.
→
6.
Push in the detergent drawer.
7.
15.3 Dispenser contents
Notes
¡
If you change the contents of the
dispenser, the basic dosage for
this dispenser is reset.
¡
If you use both dispensers for li-
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
Adjusting the dispenser contents
1.
Press and hold
i-Dos
for ap-
prox. 3 seconds.
2.
To set
, press
i-Dos
.
a
The display shows
.
3.
To set , press
i-Dos
again.
4.
To end the setting process, wait
briefly.
15.4 Basic dosage
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg. Detergent dosage
Adjusting the basic dosage
1.
Press and hold
i-Dos
for ap-
prox. 3 seconds.
a
The display shows the basic
dosage set for
.
2.
To adjust the setting, press .
