en
Faults and what to do about them
46
Information on the display panel
Display
Cause/Remedy
Õ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
I
(Start/Reload)
button or
select
Drain
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
•©£
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the
•©£
disappears on the display panel, then the door can
be opened.
|
■
Flashes
(no water supply): Water tap turned on? Filter in the water supply is
blocked?
"Filter in the water supply is blocked" on page 44
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
w
lights up
The childproof lock is activated – deactivate it.
The symbol
k
flashes
Run the
Cotton 90°C
programme to clean and care for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
■
Switching the drum care information signal on/off.
E:36
alternating with
-10
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
outlet hose.
■
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
and water drain hose are not kinked or trapped.
■
The drain pump is blocked.
"Drain pump is blocked" on page 43
■
The drain hose at the siphon is blocked.
"The drain hose at the siphon is blocked" on page 44
■
The water drain hose is connected too high. Install the water outlet hose at a
maximum height of 1 meter.
E:35
alternating with
-10
(Suitable for spe-
cial models)
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
H:95
alternating with
“Ÿš
when programme is
finished
No water detected in drying phase, may get bad drying result.