Operating the appliance
en
39
Cancel the programme
For programmes washing at high
temperatures:
1.
Touch the
Start Reload
button.
2.
To cool down laundry: Select
Rinse
.
3.
Touch the
Start Reload
button.
For programmes washing at low
temperatures:
1.
Touch the
Start Reload
button.
2.
Select
Spin/Drain
.
3.
Touch the
Start Reload
button.
For programmes in drying process:
1.
Touch the
Start Reload
button.
2.
If the
•©£
on the display panel,
waiting for the appliance running to
cool down the laundry till the
•©£
disappears.
Programme end
“Ÿš
lights up on the display and
À
and
Õ
displays are off.
If you have selected
2
, the water is only
drained after rinse process, no spin
cycle.
Notes
■
If
•©£
flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
■
If you do not take laundry out within
15 mins after drying process
finished, wrinkle guard process will
start to prevent laundry getting
wrinkled. The process lasts about 30
minutes.
0:00,
£‘˜
,
£©
and
“Ÿš
will
be displayed alternately on the
display and
Ó
symbol will be
displayed as the status symbol. You
can touch any button to terminate
this process, then the door will be
released and laundry can be taken
out.
Removing laundry/switching
off the appliance
1.
Set programme selector to
Û
(Off)
.
2.
Open the door and remove the
laundry.
3.
Turn off the water tap.
Note:
Not required for Aqua-Stop
models.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Wipe the rubber seal dry.
■
Leave the door and detergent
drawer open so that any residual
water can evaporate.
■
Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
