en
Installation and connection
14
Installation loca-
tion
Requirements
In a washer-dryer
stack
Only use the ori-
ginal connection
set from the
dryer manufac-
turer when set-
ting up this appli-
ance in a
washer-dryer
stack.
→
This appliance
must only be
stacked on a
washing machine
from the same
manufacturer.
The depth and
width of this ap-
pliance must cor-
respond with the
dimensions of
the washing ma-
chine.
Do not place the
washer-dryer
stack on a plat-
form.
Against a wall
Do not trap the
hoses between
the wall and the
appliance.
4.4 Water drain hose
Condensation forms during drying,
which your appliance uses for auto-
matic cleaning. Use the water drain
hose to drain away excess condens-
ation directly into the waste water
system.
Notes
¡
Operate this appliance using the
water drain hose provided. If you
connect the water drain hose
→
regularly empty the condensation
container →
.
¡
You can order this optional
→
our customer service.
Connecting the water drain hose
If you do not want to regularly empty
the appliance's condensation con-
tainer, connect the water drain hose.
ATTENTION!
When operating the appliance
without the water drain hose being
connected properly, liquid may leak
out of the connecting piece.
▶
Before operating the appliance,
connect the water drain hose prop-
erly to the connecting piece.
Requirements
¡
The appliance and the accessory
have been unpacked.
→
¡
The appliance is installed at the in-
stallation location.
→
Summary of Contents for WQ43G200GC
Page 39: ...Cleaning and servicing en 39 2 Clean the moisture sensor with a sponge ...
Page 49: ......
Page 50: ......
Page 51: ......