en
Troubleshooting
48
Fault
Cause and troubleshooting
Automatic self-cleaning function rinses the appliance's
heat exchanger.
1.
Not a fault.
2.
Do not pull out the condensation tank.
3.
Do not cancel the programme.
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
"Aligning the appliance", Page 16
Water drain hose is not connected correctly.
▶
Ensure that the water drain hose is connected cor-
rectly.
→
"Connecting the water drain hose", Page 14
The laundry is too
damp.
Unsuitable programme for the type of fabric.
▶
Set a timed programme for the subsequent drying.
→
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
▶
Observe the maximum load capacity of the
→
.
After the end of the programme, warm laundry feels
damper than it actually is.
1.
Remove the laundry from the drum as soon as the
drying programme has finished.
2.
Spread the items of laundry for cooling.
Unsuitable dryness level set.
▶
"Changing the dryness level", Page 25
.
Drying target not adjusted.
▶
"Adjusting the dryness level", Page 25
Load too small.
▶
Set a timed programme for the subsequent drying.
→
Moisture sensor dirty.
▶
"Cleaning the moisture sensor", Page 43
.
The drying process is interrupted and the condensa-
tion tank has been filled.
1.
"Emptying the condensation container", Page 32
.
2.
"Inserting the condensation container", Page 33
3.
Summary of Contents for WQ45G2W0EP
Page 55: ......