Operating the appliance
en
19
Programme end during rinse
hold
- - - appears in the display panel, and
the start button indicator light flashes.
To end the programme:
1.
Select
0
Spin
/Drain
p
(if only a
drain cycle is required: set rpm (spin
speed) to - - -).
2.
Select the Start button.
Programme end
End
appears in the display panel.
If the
x
symbol also appears in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Note:
Add less detergent to the next
washing cycle with the same load.
Removing laundry/switching
off the appliance
1.
Open the door and remove the
washing.
2.
Set the programme selector to the
“Off” position. The appliance is
switched off.
3.
Turn off the tap.
Not required for Aqua-Stop models.
Contents of package
~
Page 27
Notes
– Do not leave any items of laundry
in the drum. They may shrink in
the next wash or discolour
another item.
– Remove any foreign objects from
the drum and the rubber seal –
risk of rusting.
– Leave the door and detergent
drawer open so that any residual
water can dry away.
– Always remove the washing.
– Always wait until the programme
ends, as the appliance could still
be locked.
– If the display panel goes off at the
end of a programme, the energy-
saving mode is active. To
activate, select any button.
