Faults and what to do about them.
en
19
3
Faults and what to do
about them.
Faults and what to do about them.
Information on the display panel
Faults and what to do about them.
Display
Cause/remedy
Note:
The indicator lamps on the buttons and/or the status displays flash:
Rinse
and
Wash
indica-
tor lamps flash.
Close the door properly; washing may be trapped.
Spin
and
Wash
indicator
lamps flash.
Turn on tap fully, inlet hose kinked/jammed; water pressure too low, clean fil-
Spin
and
Rinse
indicator
lamps flash.
Drain pump blocked; clean the drain pump
Drain hose/outlet pipe blocked; clean drainage hose on the siphon
All indicator lamps flash. Turn off the tap, call customer service
Faults
Cause/remedy
Water is leaking from the
appliance.
■
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the inlet hose.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
■
Start button not selected?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
■
Is the inlet hose kinked or trapped?
The door cannot be
opened.
■
The safety function is activated. Cancel the programme? Wait approxi-
mately 2 minutes.
■
$
(Rinse stop = without final spin) selected?
The programme will not
start.
■
Start button selected?
■
Is the door closed?
The water is not draining.
■
$
(Rinse stop = without final spin) selected?
■
■
Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry is wet/too damp.
Not a fault – the unbalanced load detection system has interrupted the spin
because the washing is unevenly distributed. Distribute small and large items of
washing in the drum.
The programme takes
longer than usual.
■
Not a fault – unbalanced load detection system adjusts imbalance by
repeatedly distributing the washing.
■
Not a fault – foam detection system active – a rinse cycle is activated.
