en
Help with the appliance
40
3
Help with the appliance
Help with the appliance
Faults
Cause/remedy
The appliance will not start.
Check the mains plug and the fuses.
Creasing.
■
Load exceeded or incorrect programme selected for a type of fabric.
All the required information can be found in the programme
table.
■
Remove laundry from the drum as soon as the drying programme
has finished. Creasing occurs when clothing is left in the drum.
Water is leaking out.
The appliance may be positioned at an angle. Level the
appliance.
Programme duration displayed
changes as drying progresses.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Laundry is not dried properly or
is still too damp.
■
After the programme has ended, warm laundry feels damper than it
actually is. Spread out the laundry and let it cool down.
■
Adjust the drying time or increase the degree of dryness. This will
extend the drying time but the temperature will remain the same.
■
Select a timed programme to add extra drying time for laundry that is
still damp.
■
Select a timed programme for a small load.
■
Do not exceed the maximum load for a programme.
■
Clean the moisture sensor in the drum. The sensor may become cov-
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.
■
Drying has been interrupted as a result of a power cut, because the
condensation container is full or because the maximum drying time
has been exceeded.
Note:
The programme will not start
Make sure that:
■
The door is closed.
■
Child lock 3 sec.
w
has been deactivated
■
You have pressed Start/Pause
Ü
Note:
If the programme has been delayed by setting
Finish in
5
, the
programme will start later.
Drying taking too long.
■
The appliance may have fluff in it. This will increase the drying time.
■
If the air inlet on the appliance is blocked or not fully open, the drying
time may increase. Make sure that the air inlet remains unob-
structed.
■
If the ambient temperature is lower than 15 °C or higher than 30 °C,
this may increase the drying time.
■
Inadequate air circulation in the room may increase the drying time.
Make sure the room is adequately ventilated.
Summary of Contents for WT45W460IN
Page 47: ...6 ...