Information on the display
en
39
Y
Information on the display
Information on the display
--------
Note:
If you cannot rectify the fault yourself by turning the appliance off and then on again,
please contact our after-sales service.
Faults
Cause/remedy
ð
on the display and
drying has stopped.
■
Empty the condensation container and reinsert it.
Press Start/Pause
Ü
.
■
Once you have installed the optional drain hose*, make sure that it:
Is correctly connected
Is free of kinks
Is not blocked or clogged, e.g. with deposits
¥
on the display.
Remove the fluff.
Press Start/Pause
Ü
.
é
on the display.
Not a fault. The heat exchanger is being cleaned automatically. Do not pull out
the condensation container while this is displayed.
The display goes out and
Start/Pause
Ü
flashes.
Not a fault. Energy saving mode is active .
* Depending on how the appliance is equipped or the available accessory
Summary of Contents for WT45W460IN
Page 47: ...6 ...