en
Refresher
38
5.
Pour distilled water into the filling
hole on the refresher tank using the
jug provided until
ò
goes out on the
display.
Make sure that you pour the distilled
water into the correct filling hole.
Caution!
The appliance may be
contaminated with fluff or be
damaged by deposits.
Fill the refresher tank with distilled
water only. Do not use condensation
water or additives.
Note:
The refresher uses
approximately 450 ml of distilled
water during the drying cycle. If you
have poured more than 700 ml of
distilled water into the filling hole and
ò
does not go out on the display,
either you have poured the distilled
water into the wrong filling hole or
the appliance is not level. Pour the
distilled water into the correct filling
hole or make the appliance level.
6.
Push the condensation container
back into the appliance until you feel
it lock into place.
7.
Press
(Start/Pause)
Ü
.
Cleaning the filter in the
refresher tank
The filter in the refresher tank prevents
the refresher tank from being
contaminated.
1.
Pull out the condensation container
horizontally.
2.
Remove the filter and clean it under
running water or in the dishwasher.
3.
Reinsert the filter.
Caution!
Risk of damaging the appliance.
Only operate the appliance with the
filter inserted.