ʑ
v
@c
@c
ʑ
v
gü
a
\
a
u
a
u
10
Installation
– Scope of delivery: dryer, installation and instruction manual, jug, basket for woollens
(depending on the model).
– Check dryer for transport damage.
– The dryer is heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not install in a room where there is a risk of freezing. Freezing water may cause damage.
– If in doubt, have the appliance connected by a specialist.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Setting up the dryer
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
and firm surface.
– Keep the cooling grille on the front of the dryer
clear.
– Keep the area around the dryer clean.
– Level the dryer using the threaded feet.
Use a spirit level.
– Do not remove the threaded feet under any
circumstances.
Mains connection
see safety information
a
page 13.
– Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (
a
Page 11
) must be the same.
– The connected load and necessary fuse protection are specified on the rating plate.
Converting the installed load
Note the fuse protection of the socket.
10/16 Amps
Frost protection / Transport
Preparation
1. Empty the condensation container
a
page 4
.
2. Select any programme using the programme selector.
3. Press the
start
button
a
condensation is pumped into the container.
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to
Off
.
The water tank must not contain any distilled water. If necessary, run the Steam/Refresh programme.
1.
Remove all accessories
from the drum.
The drum must be empty.
Make sure that the air inlet
remains unobstructed
Clean and level
Do not install the dryer behind a door or sliding
door, which could prevent or restrict opening of the
dryer door. This will prevent children from locking
themselves in and putting their lives in danger.
2.
3.
turn to
Off
Press and hold selection
then turn 3 x to the right
turn to
Off
Set
amperage
1 x to the
right
Feedback
Do not operate the dryer if there
is a danger of frost.
10 A
16 A
11
Technical data
ʠ
Dimensions (DxWxH)
60 x 60 x 85 cm (adjustable height)
Weight
approximately 43.5 kg
Max. capacity
8 kg
Condensation container
4.0 l
Water tank
approx. 0.4 l
Connection voltage
220-240 V
Connected load
max. 2800 W
Fuse protection
16 A / 10 A
Ambient temperature
5 - 35 °C
Product number
Production number
Inside of door
The rating plate can be found on the back of the dryer.
ʠ
Drum interior light
(depending on model)
(bulb E14, 25 W)
The drum lights up after the door is opened or closed, and after the programme starts,
and switches off automatically. Changing the bulb
a
page 12.
Consumption rates
(The value on the label is achieved at the maximum heat setting.)
Fabrics/programmes
Residual moisture in the
fabrics after spinning
Drying time**
Energy consumption**
Ê
Cottons 8 kg
10 A
16 A
10 A
16 A
+c
Cupboard Dry*
1400 U/min
(50%)
137 min
111 min
4.01 kWh
4.01 kWh
1000 U/min
(60%)
155 min
129 min
4.82 kWh
4.82 kWh
800 U/min
(70%)
173 min
147 min
5.55 kWh
5.55 kWh
|
Iron Dry*
1400 U/min
(50%)
114 min
88 min
2.40 kWh
2.40 kWh
1000 U/min
(60%)
132 min
106 min
3.69 kWh
3.69 kWh
800 U/min
(70%)
150 min
124 min
4.14 kWh
4.14 kWh
Easy-Care 3.5 kg
+c
Cupboard Dry*
1000 U/min
45 min
39 min
1.05 kWh
1.05 kWh
800 U/min
(40%)
48 min
42 min
1.35 kWh
1.35 kWh
600 U/min
(50%)
60 min
51 min
1.65 kWh
1.65 kWh
* Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Fabrics/programmes
Drying time
Annual energy consumption
Ê
Cottons 8 kg / 4
ü
kg
*
Cupboard Dry
+
***
98 min / per cycle
581
ü
kWh / per year
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
Optional accessories
(from after-sales service using order number, depending on the model)
Platform
For easier loading and unloading. The basket contained in the drawer can be used to carry
the laundry.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer
must be
fastened to the washing machine using this connection set.
With pull-out worktop: WZ 20300
Connection fittings for condensation outlet
The condensation is conveyed directly via a hose.
Installation underneath the worktop
Instead of the appliance covering plate, you
must
have a metal cover fitted by a specialist.
WZ
20500
WZ
20310
WZ
20160
WZ
20290
ʠ
ʠ
a
ʠ
ā
a
ʠ
4
a
a
ʠ
u
a
a
ʠ
ʠ
ʠ
ʠ
ʠ
a
ʠ
ʠ
a
a
a
a
a
ʠ
ʠ
a
a
ʠ
ʠ
a
a
a
a
a
a
a
a
a
a
a
a
