Draining the condensation water
en
15
Transport and frost protection
1.
Empty the condensate container.
2.
Select any programme using
the programme selector.
3.
Press the Start button.
4.
Wait for 5 minutes.
Note:
The condensation is drained.
5.
Empty the condensate container
again.
6.
Switch off the dryer.
Note:
Despite draining, there will
always be some residual water in
the dryer.
Caution!
Any residual water may leak out
and cause material damage.
Transport the dryer in an upright
position.
Caution!
The dryer contains coolant and may be
damaged.
Allow the dryer to rest for two hours
before initial use.
Œ
Draining the
condensation water
Draining the condensation water
Condensation will form in the appliance
as it dries the laundry.
You must ensure that the drain hose is
connected when you operate the
appliance.
If there is no drain hose connected to
the appliance, the condensation water
from the appliance will run into the
condensation container. In this case,
you will need to empty the condensation
container each time the dryer finishes
drying the laundry, and also if it
becomes full before drying is complete.
Connect the drain hose as follows:
1.
Remove the accessories from the
dryer drum.
2.
When the dryer is delivered from the
factory, the hose for discharging the
condensation into the condensation
container is fastened to the
connecting piece.
3.
Disconnect the hose from the
connecting piece and put it in the
"parked" position.
Summary of Contents for WT46W491GB
Page 39: ...6 ...