en
Faults and what to do about them
34
Note:
If you cannot rectify the fault yourself by turning the dryer off and on, please contact
our after-sales service.
Drying time too long?
■
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
ter.
■
If the air inlet on the dryer is blocked or not freely accessible, this may
increase the drying time. Make sure that the air inlet remains unobstructed.
■
The optimum ambient temperature for drying is between 15 °C and 30 °C.
Outside of this range, the drying time may increase.
■
Insufficient air circulation in the room may increase the drying time. Venti-
late the room.
Display panel goes off
and Start button flashes.
Not a fault. Energy-saving mode is active
Residual water in
the condensate con-
tainer despite the dryer
being connected to
the condensation drain*.
Not a fault. If the condensation drain is installed, residual water remains in
the condensate container due to the dryer's self-cleaning function.
Humidity in the room
increases.
Not a fault. Make sure the room is sufficiently ventilated.
Power cut.
The drying programme is interrupted. Remove the laundry and spread it out,
or restart the programme.
Unusual noises when
drying.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger
The dryer feels cold
despite drying.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.
Faults
Cause/remedy
* Depending on the model
Summary of Contents for WT47W4E9DN
Page 39: ...6 ...