en
Installation and connection
14
During installation ensure that:
■
The dryer is placed on a clean, level
and firm surface,
■
The mains plug can be accessed at
all times,
■
The air inlet on the dryer is kept clear
and there is sufficient ventilation,
■
The area around the dryer is kept
clean and
■
The dryer is levelled using the
threaded feet.
Note:
Check the alignment of the
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
Note:
If in doubt, have the appliance
connected by a specialist.
Transport and frost protection
1.
Empty the condensate container.
2.
Select any programme using
the programme selector.
3.
Press the Start button.
4.
Wait for 5 minutes.
Note:
The condensation is drained.
5.
Empty the condensate container
again.
6.
Switch off the dryer.
Note:
Despite draining, there will
always be some residual water in
the dryer.
Caution!
Any residual water may leak out
and cause material damage.
Transport the dryer in an upright
position.
Caution!
The dryer contains coolant and may be
damaged.
Allow the dryer to rest for two hours
before initial use.
Summary of Contents for WT47W560TR
Page 39: ...6 ...