Installation and connection
en
29
Changing the condensation
drain
Notes
■
The condensation from the dryer can
either be discharged into the
condensate containercondensate
container or drained off via a
connection to the waste-water
system. At the factory, the
condensation from the dryer is
discharged into the condensate
container.
■
If the condensation drain is installed,
residual water remains in the
condensate container because of
the dryer's self-cleaning function.
Change the condensation drain as
follows:
1.
Remove the accessory from the
dryer drum.
2.
Delivery status of the dryer. The hose
for discharging the condensation
into the condensate container is
secured to the connecting piece.
3.
Disconnect the hose from the
connecting piece and move it into
the "parked" position.
4.
Remove the drain hose from the
accessory and secure it to the empty
connecting piece.
5.
Depending on how you connect the
hose (A, B or C), secure the drain
hose with the remaining accessories
on the other side.
Caution!
Blocked water can be drawn back
into the dryer and may cause
material damage.
Check that the water can flow away
quickly out of the wash basin. The
drain must not be sealed or blocked.
Caution!
Material damage due to leaks or
draining water.
Secure the drain hose so that it
cannot slip out. Do not kink the drain
hose. Observe the height difference
between the installation surface and
the drain of max. 100 cm, and 80
cm for a drain in a siphon.
