en
Operating the appliance
32
Programme sequence
The programme status is indicated in
the display field.
Changing the programme or
adding laundry
You can remove or add laundry and
change or alter the programme at any
time during drying.
1.
To pause the programme, open the
dryer door or press the Start button.
2.
Add or remove laundry.
3.
Select another programme or an
additional function, if required.
4.
Close the dryer door.
5.
Press the Start button.
Note:
The programme duration in the
display panel is updated depending on
the load and residual moisture in the
laundry. The values displayed may
change after the programme is
changed or the load is adapted.
Cancelling the programme
The programme can be interrupted at
any time; to pause, open the dryer door
or press the Start button.
Caution!
Risk of fire. Laundry may catch fire.
If you cancel the programme, you must
remove the laundry items and spread
them out so that the heat can disperse.
Programme end
FINISHED, REMOVE WASHING.
appears in the display panel.
Removing laundry and
switching off the dryer
1.
Remove the laundry.
2.
Press the
#
button to switch the
dryer off.
Clean the fluff filter
Note:
During drying, fluff and hair from
the laundry is trapped by the fluff filter. If
the fluff filter is blocked or dirty, this
reduces the flow of air, which prevents
the dryer from achieving its maximum
performance. Clean fluff filters also
reduce energy consumption and the
drying time.
Clean the fluff filter
after each
drying
cycle:
1.
Open the dryer door and remove all
fluff from the door.
2.
Pull out the two-part fluff filter.