Faults and what to do about them
en
27
Water is not drained.
■
- - - -(Rinse stop= without final spin) selected?
■
■
Clean outlet pipe and/or drainage hose.
Water not visible in the
drum.
Not a fault – water below the visible area.
Spin result not satisfac-
tory.
■
Wash small and large items of washing together.
■
䖫ᶮ⟘
(
Less iron)
selected?
■
Too low speed selected?
Spin cycle activated sev-
eral times.
Not a fault – unbalanced load detection system adjusts imbalance.
Dispenser not completely
rinsed out.
■
Remove the insert. Clean detergent drawer and re-insert.
Stain formation in the
washing machine.
Run
ㆂ⌱
(
Drum clean) 90 °C
programme without washing.
Use standard detergent.
Foam is coming out of the
detergent drawer.
Too much detergent used?
Mix 1 tablespoon of fabric conditioner with ½ litre of water and pour into
dispenser
II
in the detergent drawer.
Reduce detergent dosage for the next wash cycle.
Excessive noise, vibra-
tions and wandering dur-
ing spin cycle.
■
Appliance aligned?
■
Appliance feet fixed?
■
Transportation safety devices removed?
Remove transportation protection devices.
Display panel/indicator
lights do not function
while the appliance is run-
ning.
■
Power failure?
■
Circuit breaker tripped? Reset the circuit breaker /change the fuse.
■
If the fault occurs repeatedly, call the after-sales service.
Programme duration
changes during the wash
cycle.
■
Not a fault – unbalanced load detection system adjusts imbalance by
repeatedly distributing the laundry.
■
Not a fault – foam detection function active. Additional rinse cycle.
Detergent residues on the
laundry.
■
Occasionally phosphate-free detergents contain water-insoluble residues.
■
Select
অ┲⍇
(
Rinse)
or brush the laundry after washing.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
■
Set programme selector to
$
㉮䵴
(Off)
and pull out the mains plug out of the socket.
■
Turn off the tap and call the after-sales service.
Faults
Cause/Remedy
