Cleaning and maintenance
en
23
2.
Clean the measuring aid and cover
with water and brush.
3.
Install the cover back to the
measuring aid. Pay attention to the
assemble mark, and press the cover
until click sounds.
Drain pump blocked
Note:
Turn the tap off to prevent more
water from flowing in and to ensure that
it is drained via the pump.
:
Warning
Danger of scalding!
Wash liquor is hot when washing at high
temperatures. You may be scalded if
you touch the hot wash liquor.
Allow wash liquor to cool down.
1.
Switch off the appliance. Pull out the
mains plug.
2.
Open the service flap.
3.
Take the drainage hose out of the
holder.
4.
Remove cover flap, drain water into
a suitable receptacle. Press on
cover flap and insert drainage hose
into the holder.
Note:
Residual water may run out.
5.
Carefully unscrew the pump cover.
Clean the interior, pump cover
thread and pump housing (fan
impeller in the detergent-solution
pump must rotate).
6.
Reinsert and screw on pump cover.
Handle should be vertical.
7.
Close service flap. If required,
engage disengaged service flap
beforehand.
Note:
To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser
II
and start the
অ㝡≤
(
Spin)
programme.