en
Faults and what to do about them
32
3.
Pull down emergency release with
a tool and release.
Door can then be opened.
Information on the display panel
Display
Cause/Remedy
A:01
Close door immediately on account of the increasing water
level. If an interruption occurs, A:01 and
‹˜“¯
are displayed
alternately.
A:02
Door is locked for reasons of safety (water level and/or
temperature too high).
Washing programme:
In top-up mode A:02 and
˜‘—†
are
displayed alternately. If you have to open the door, wait until
the temperature has dropped slightly or pump out the water
(select e.g. Spin/Rinse).
Drying programme:
If you have to open the door, wait until
the temperature has dropped slightly or set the drying
programme to 15 min to cool down the washing.
If A:02 is frequently displayed at the end of the drying
programme:
Run the
Drum clean
programme without washing.
A:03
Door cannot be locked/unlocked due to high temperature.
Leave machine switched on for about 1 min. Then the
machine can be locked/unlocked again.
hot
Door cannot be opened after the drying programme due to
the high temperature. The cooling process continues until the
display goes out and the door can be opened.
|
Flashes (no water supply). Tap turned on? Air filter blocked?
Is lit (low water pressure): Is provided for information only. No
effect on programme progress. The programme duration is
extended.
E:18
Drain pump blocked; clean drain pump.
the drainage hose on the siphon.