en
Installation and connection
40
Electrical connection
Electrical safety
:
Warning
Danger of death from electric shock!
Danger of death if live parts are
touched.
■
Never pull out the mains plug by
tugging the power cord.
■
Insert/pull out the mains plug with
dry hands only.
■
Never pull out the mains plug during
operation.
■
Connect the washing machine to an
alternating current via a correctly
installed earthed socket only.
■
The mains voltage and voltage
specifications on the washing
machine (appliance rating plate)
must match.
■
Connected load as well as required
fuse are indicated on the appliance
rating plate.
Ensure that:
■
the mains plug and socket match,
■
the cable cross-section is adequate,
■
earthing system has been installed
correctly.
■
A damaged power cord may
be replaced by an electrician only.
A replacement mains cable can be
obtained from customer service.
■
Do not use multiple plugs/couplings
or extension cables.
■
If a residual-current-operated circuit
breaker is used, use only a type
which features this symbol:
z
.
Only this symbol guarantees
compliance with the currently valid
regulations.
■
The mains plug must be accessible
at all times.
Before washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean
programme the first time
without
washing.
Note:
The washing machine must have
been installed and connected properly.
1.
Check the machine.
Note:
Never switch on a damaged
machine. Inform your customer
2.
Insert mains plug.
3.
Turn the tap on.
4.
Switch on the appliance.
5.
Close the washing machine door.
Do not load any washing.
6.
Select
Drum clean
40°C
programme.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into
dispenser
II
.
9.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
standard or mild detergents.
10.
Close the detergent drawer.
11.
Select
Start
/Reload.
12.
When the programme ends, switch
off the appliance.
Your washing machine is now ready
for use.
Transportation
1.
Remove covers and keep in a safe
place.
If required, use a screwdriver.