Auto Shut-off and Auto Wake-Up:
E1: A warning beep (and E1 warning will appear on the digital display for Empressa
model only) will signal if the Pressing Plate is left in a closed position against the
Ironing Board for more than 10 seconds. The press will stop heating and the Auto
Shut-off feature will initiate unless the Pressing Plate is restored to the lifted position.
The Auto Wake-Up feature will then kick in. In some cases, you will need to either turn
press off and then on again or unplug then re-plug the unit in to reset function.
CAUTION: Do not lock Pressing Plate and Ironing Board together as a beep
and/or an E1 warning will appear and press will begin to beep. Only lock when
storing.
E2: A warning beep (and E2 warning will appear on the digital display for Empressa
model only) will signal if the pressing plate is left in lifted position without use for
approximately 10 minutes. The press will stop heating and Auto Shut-off feature will
engage. In order to restore use, simply press On/Off Switch or press Temperature
Control buttons to reset press.
IMPORTANT NOTE: If you forget to raise the Pressing Plate or become
distracted, the machine will give a warning beep then automatic shut-off
feature will initiate and/or an E2 warning will appear. The steam press will be
completely shut-off after about 10 minutes of no activity with the press in the
open position.
Warning: During initial use or after a long period of time without use, press
the Steam Burst Button continuously for several seconds to clear Pressing
Plate of residual water or calcium buildup in system before use.
NOTE: Some garments have details such as darts, curved seams, and shoulder pads
which should not be pressed
fl
at. Use Pressing Cushion provided for use in these areas.
Warning: Do not attempt to lower the Pressing Plate to its lowest position or
lock the press with the Pressing Cushion in between. You may damage your
press by doing so.
BASIC IRONING
Tablecloth:
Fold the length of fabric in either half or thirds and place on
the Ironing Board.
Accordion pleat the length on the Ironing Board and move
the pleated item into the large open space behind the
Ironing Board.
Move the tablecloth towards you, then press.
Continue moving forward until the entire item is pressed.
To store, fold it, place it on the Ironing Board and close
the press. Apply mini-pressure. If necessary, refold the
tablecloth to press any areas that were hanging off the
sides of the Ironing Board. Repeat the pressing procedure.
9
