NOTE: It is recommended that another high wattage appliance is not operated on the
same circuit to avoid a circuit overload.
CAUTION: Upon initial use, please hold trigger to allow the water to flow
thru the system for approximately 30 seconds to prime the unit.
WARNING: ON SURFACES THAT HAVE BEEN TREATED WITH WAX, THE
WAX MAY BE REMOVED BY THE HEAT AND STEAM ACTION. DO NOT USE ON
UNSEALED WOOD FLOORS OR LET UNIT STAND ON ANY WOOD FLOOR FOR AN
EXTENDED PERIOD OF TIME. THIS MAY CAUSE THE WOOD GRAIN TO RISE.
IT IS RECOMMENDED THAT A SECTION BE TESTED IN AN ISOLATED AREA OF
THE FLOOR. IT IS ALSO RECOMMENDED THAT YOU CHECK THE USE AND CARE
INSTRUCTIONS FOR CLEANING FROM THE FLOOR MANUFACTURER TO ENSURE
STEAM CLEANING IS ACCEPTABLE FOR YOUR FLOOR.
8) Slowly pass over surface to be cleaned while pressing trigger to emit steam. It is
recommended to use the sweeper option prior to using the steam mop by pressing
Sweeper button located on the sweeper head. Press again to stop sweeping.
WARNING: BE AWARE THAT THE SWEEPER SETTING, WHEN USED ON
CARPET, IS INTENDED FOR LOW PILE CARPET ONLY. IT IS RECOMMENDED
THAT A SMALL ISOLATED AREA BE TESTED PRIOR TO PROCEEDING WITH THE
SWEEPER OPTION ON YOUR CARPET.
9) With steam control options, (available on models Aqua Pro & Aqua Pro V) push
button to choose a setting that best fits your cleaning needs. Scrub for deep
cleaning, mop for general day to day cleaning, or dust for quick cleaning.
CAUTION: To sanitize an area of your floor, leave the steamer over the
area for a minimum of 8 seconds, but no longer than 15 seconds. Leaving the
steamer in a stationary position for a longer period than recommended may
cause build up of pail residue. This residue can be removed by using a
decalcifying product or with a few drops of vinegar.
10) When steamer stops emitting steam, after approximately 15 to 20 minutes of use,
simply remove the water tank, refill, and continue cleaning.
Dynamo Pro
Steam
control
DUST
MOP
SCRUB
P
u
s
h
b
a
c
k
w
a
rd
t
o
re
m
o
v
e
w
a
te
r
ta
n
k
5
