ASSEMBLY INSTRUCTIONS
NOTE:
PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE
HOW YOUR FRAME IS ASSEMBLED.
IMPORTANT:
WE ADVISE YOU TO ASSEMBLE THE STRUCTURE ONCE
BEFORE GOING OUT TO BECOME FAMILIAR WITH THE ASSEMBLY OF
THE TENT.
NOTE:
To take down canopy, follow steps above in the reverse order. Place
stakes into stake bag and poles into pole bag, which are provided. The canopy
should be folded into equal parts toward the center to distribute the bulk. Place
pole bag on canopy and start a small tight roll, the width of your carry bag. Once
rolled, secure with strings or rope and place into carry bag.
STEP 2:
Stake the canopy to the ground by inserting
stakes though the webbing loops at the side corners
of the structure. Hammer the stakes into the ground at
a 45° angle, making sure the sides are pulled out evenly.
STEP 3:
Extend the poles by pulling out each section and
placing the ends into the metal ferrule connectors. You
will have 2 poles.
STEP 4:
Slide each fiberglass pole (A) through the sleeves on the top of the
canopy roof. diagonally across tent body, making sure the poles pass thru
sleeves. Position poles so that equal pole lengths extend on either side of the
pole sleeves.
STEP 6:
Clip the plastic hooks to the fiberglass frame
poles.
STEP 7:
There is a large black hook that goes over
both poles where the poles cross at the sides of the
canopy to hold them together.
STEP 1:
Spread canopy out flat with pole sleeves up.
MODEL
90154420T
Gameday Shelter
90” x 60”
Top view.
A
A
RECCOMENDED FOR AT LEASET 2 PEOPLE TO SET UP
Canopy should
appear as shown.
NOTE:
Sandbags are provided for use at the beach. Fill the bags with sand to
hold the canopy in place.
MAKE SURE CANOPY IS CLEAN AND DRY BEFORE STORING.
STEP 5:
Starting at one side of the canopy, place the
ends of the fiberglass frame pole into the fast feet located
at the base of the canopy. Walk to the other side. Push
upward on the pole to create an arch. Place pole ends
into remaining fast feet.
