3.0
Gas Supply continued.
Gas supply piping should be of an adequate size. Refer section 4 of AG601. Particular
attention should be paid to section 4.11 of AG601 concerning the location and depth of
cover for consumer piping.
The complete installation must be tested for soundness as per section 2.6 of AG601.
4.0
Installation Instructions
4.1
Packing
The patio heater will arrive packed in two cartons which will contain ready to assemble
parts i.e.:-
a. Reflector
b. Cone shaped emitter
c. Support stand base assembly
4.2
Assembly of Patio Heater (Fig. 1)
1. Stand the base assembly (e) on a flat even surface.
2. Remove bottom cover on assembly (b) by unscrewing 3 x M5 screws. This will expose
the inner frame and gas regulator connection.
3. Secure the reflector assembly (a) and cowling to the cone shaped emitter with the 3 x
M8 thumbscrew.
