Figure 2
Figure 3
Figure 4
Figure 5
3.
If the hearth and fireplace floor are not at the same
elevation, leveling legs may be installed on the rear of the unit
(Figure 4)
for distances of up to 1". For larger distances
shimming may be used using a non-combustible material. A
Hearth Base Support is available from your dealer for
installations where the hearth is below the fireplace opening
(Figure 5)
.
NOTE: THE INSERT WEIGHT IS SUBSTANTIALLY
FRONT HEAVY AND IF NOT FULLY SUPPORTED IT
COULD FALL FORWARD.
4.
Install vent system into existing chimney by using 3" flex
from left side of hearth, passing damper and continuing to
the top of the chimney. If the total vent length is longer than
10 Feet, install Ø4" vent from that point to top of chimney
(Figure 6)
.
5.
Pack fiberglass insulation around the vent pipe and
combustion air duct. Install a flashing cover over
chimney. Secure flashing and seal as required. Install
listed vent cap and secure.
6.
Measure fireplace opening and adjust hopper top to the
required level allowing for installation clearance. This is
accomplished by removing the four #8 screws on the sides
3
