6-2
•
Service Information
UDA-8705A User Manual (Rev. 1.1)
Power LED Conditions
The top front edge of the module has a Power LED which indicates card status. The Power LED
displays the following conditions:
•
Off
no power to the card.
•
Amber
the card is running internal diagnostics while powering up.
•
Green
normal operation.
•
Flashing Green
the card is waiting for a software upgrade.
•
Red
solid or flashing means the card is not operational. Reseat card in frame, check
the Rear Module type and connections, or call Sierra Video Technical Support.
Bootload Button
In the unlikely event of a complete card failure, you may be instructed by a Sierra Video Technical
Support specialist to perform a complete software reload on the UDA-8705A. Contact Sierra Video
Technical Support for the latest software load for your card.
Use the following procedure to perform a complete software reload on the card:
1.
Eject the card.
2.
Press and hold the
Bootload
button, while re-inserting the card into the frame.
3.
Release the button.
The
PWR LED
will flash GREEN while the card is waiting for a new software load.
If a new software load is not sent to the card within 60 seconds, the card will attempt to
restart with its last operational software load.
This completes the procedure for performing a complete software reload on the card.
Sierra openGear Warranty
A. General
Buyer assumes all responsibility for ascertaining the suitability of Sierra Video Systems (hereinafter "SVS") products for
Buyer's intended use. No product sold by SVS is designed or manufactured for use in any manner or under any
conditions other than those described in SVS's instruction manuals and other printed material for each particular product.
If any product is used or applied in a manner or under conditions not specifically authorized by such written materials or
if any product is used by unqualified or improperly trained personnel, Buyer agrees that SVS shall have no liability of
any kind arising from such use, and Buyer agrees to indemnify and hold SVS harmless from any claims of third parties
arising from such use, and Buyer shall provide SVS with counsel of SVS's choice to defend against such claims.
B. Limited Warranty
1. This warranty applies only to the original purchaser and is non-transferable. This warranty begins on the date of
purchase and will be in effect for five (5) years for new equipment or and for three (3) years for "Factory Refurbished"
equipment. Buyer must obtain a Return Material Authorization ("RMA") number from SVS prior to returning a product
for repair. If, in SVS' sole discretion, the product is found to be defective during the term of this warranty, SVS will at its
option: (a) provide free replacement parts, and/or (b) repair the unit at an SVS facility. During the warranty period, SVS
will make every reasonable effort to support critical emergencies by supplying no-cost loan equipment while the
defective unit is being repaired. SVS will provide replacement parts and/or factory service at no charge. Buyer bears the
Summary of Contents for openGear UDA-8705A
