Installation and Startup
Rev 3 Feb.17
26
4118699
Figure 2-14: Power Cable Locking Connector
2.
When power is supplied to the MG90, it powers up automatically. If it does not
turn on, make sure that the:
·
Power connector is plugged in and supplying voltage greater than 11 V.
Note: Although the MG90 operates in the range 7 V–36 V, low voltage
standby mode is enabled by default, so in order to avoid the router powering
on in standby mode, ensure that it is supplied with more than 11 V at startup.
·
Ignition Sense (pin 3) is connected to the battery or power source (see
on page 20 for details)
LED Behavior
Figure 2-15: MG90 LED Status Indicators (front panel)
Locking connector
GNSS Wi-Fi
Network Signal Activity Power
Table 2-5: LED Behavior
LED
Color / Pattern
Description
GNSS
Solid Green
Satellite fix available
Flashing Amber
No satellite fix available
Off
GNSS is off/disabled