PinPoint X 1x/EV-DO
46
20070914
Figure 6-6: ACEmanager : Low Power
Wiring the PinPoint X for
When the Standby Ignition Sense is enabled and the ignition sense connector is
wired to your vehicle, the ignition sense will provide a link to the modem to enable
it to enter a low-power using standby mode.
The white wire of the three wire connector should be used to connect to your
ignition.
Figure 6-7: Ignition Sense Power Connector
Power Effect on Modem State
Once the transition from powered on to standby, low-power mode starts, the
modem will change state to AT mode. This results in the current mode being
gracefully terminated. For the brief period when the modem is preparing for low-
power mode, the modem will remain in AT mode. At that time, it won't auto-
answer, ATD will fail, etc. Once low-power mode is entered, the modem will then
discard any data received on the host port.
When the modem is woken from low-power mode, the same behavior occurs as
upon power on. The modem starts in AT mode, and then after 5 seconds will
enter the default start-up mode as it is configured for the modem.
Monitoring Power-In Voltage
The current status of the power-in voltage can be monitored in ACEmanager.
Ignition Sense (white)
Power (red)
Ground (black)
Not Used
Summary of Contents for AirLink PinPoint X
