Sierra Thermostat griddle
----------------------------------------------------------------------------------------------------------------------------------------------------------------
OPERATOR’S MANUAL
Page
3
INSTALLATION CLEARANCES
COMBUSTIBLE CONSTRUCTION NON-COMBUSTIBLE CONSTRUCTION
Back:
6” 0”
Sides:
6” 0”
INSTALLATION CODES AND STANDARDS
The griddle must be installed in accordance with:
In the United States of America:
1
State and local codes.
2
National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition). This shall include but not be limited to:
NFPA #54 Section 10.3.5.2 for Venting. Copies may be obtained from The American Gas Association
Accredited Standards Committee Z223, @ 400
N. Capital St. NW, Washington, DC 20001 or the Secretary Standards Council, NFPA, 1 Batterymarch Park
Quincy, MA 02169-7471
NOTE: In the Commonwealth of Massachusetts All gas appliances vented through a ventilation hood or
exhaust system equipped with a damper or with a power means of exhaust shall comply with 248 CMR.
3. NFPA Standard # 96
Vapor Removal from Cooking Equipment
, latest edition, available from the National Fire
Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1
Local codes.
2
CAN/CSA-B149.1 Natural Gas Installation (latest edition)
3
CAN/CSA-B149.2 Propane Installation Code (latest edition), available from the Canadian Gas
Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3
GRIDDLES MOUNTED ON STANDS WITH CASTERS
Griddles mounted on stands with casters must use a flexible
connector (not supplied) that complies with the Standard for
Connectors for Movable Gas Appliances ANSI Z21.69•CSA6.16, and
a quick-disconnect device that complies with Gas Fuel, ANSI
Z21.3•CSA6.9. In addition, adequate means must be provided to limit
movement of the appliance without depending on the connector and
the quick-disconnect device (or its associated piping) to limit
appliance movement. Attach the restraining device at the rear of the
griddle as shown in Fig. 1.
Fig. 1
If disconnection of the restraint is necessary, turn off the gas supply before disconnecting. Reconnect the
restraint prior to turning the gas supply on and returning the griddle to its installation position.
Casters are only supplied on a griddle stand. If the griddle is moved for any reason the griddle should be
re-leveled (see LEVELING in this manual).
