USER GUIDE
www.SierraTeck.com
SMARTSOUND - MOTION ACTIVATED AUDIO PLAYER
info@SierraTeck.com
9
Mode Selection
MODE 1. Play a single file every time
o
With device is on, press button “A” or “B” to traverse audio files until desired track is
selected
o
Once desired track is playing, press button “A” until indictor starts flashing
MODE 2. Play multiple files in sequence
o
With device on, press button “A” until indictor starts flashing
MODE 3. Play multiple files randomly
o
With device on, press buttons “A” and “B” until indictor starts flashing.
TIP for Mode 2:
Sequence of audio played follows the same sequence you used to transfer files to
the microSD card
For example, if you have files called 001.mp3, 002.mp3, and 003.mp3 and you
copy those files to the microSD card in this sequence:
002.mp3
then 003.mp3
then 001.mp3
then playback under mode 2 will be in that same sequence
If you have many files and would like to playback in a particular sequence without
copying one file at a time, see the “Frequency Asked Questions” section.
Once motion is detected and audio is being played, the unit will not interrupt audio playback. It
will keep playing the current file until completion, after which it will wait approximately 2
seconds and start detecting new motion again. For best performance:
o
do not put more than 255 files on the memory card or use a card with capacity
greater than 8 GB
o
While unit supports up to 32GB cards, larger capacities may increase time
between motion detection and audio playback
