40
C
GB
2.6 FITTING THE WHEELS
(where supplied).
CAUTION - RISK OF CRUSHING!
This operation requires two or three
people.
1 - Perform steps 1, 2 and 3 listed in paragraph
2.5.
2 - Fit the wheel (Fig. 8a, pos. A) by screwing it into
the brass component (Fig. 8a, pos. B) on the display
unit ducting.
3 - Perform steps 5, 6 and 7 listed in paragraph
2.5.
CAUTION! The wheels fitted with a brake
(Fig. 8b, pos. C) should be fixed to the
operator side of the product; the number
of wheels will vary depending on the
length of the display unit.
If the body is to be coupled with other
NON QUAD/
MAXIM
units, fit the coupling end panel (which is
delivered with the relevant accessories) as described
below (Fig. 11):
- Select the coupling end panel.
- Adjust it to fit the contours.
- Position it in such a way that its edges coincide with
the contours of the two modules.
- Join the two modules together.
Position the glass side panel supplied in the
corresponding groove.
Fig. 8-a
B
A
Fig. 8-b
Summary of Contents for - QUAD B-30
Page 153: ......
