47
GB
- Slot in the sliding panels, if provided (Fig. 22).
- Adjust the alignment and level the unit using the
feet.
NOTE!
Fix the locknuts for the feet in place.
NOTE!
Make sure that the front glass cover of
the display unit adheres perfectly to the
silicone seal on the front panel.
2.10 ELECTRICAL CONNECTION
This procedure should be performed by an electrical
technician (in compliance with the current local
regulations of the country where the display unit is
installed).
Perform the electrical connection following the
system diagram.
CAUTION!
The main isolator switch (Fig. 23) must
be installed by an electrical technician
in compliance with current local
regulations.
2.11 NOTES ON THE ENVIRONMENT
- Packaging
Do not discard any elements of the counter
packaging, but separate it according to the type of
material used (cardboard, wood, steel, polyester,
etc…) and dispose of these in accordance with
current legislation in the country where the counter
is operated.
- Disposal
When the counter can no longer be used, proceed
as follows:
Collect all the refrigerant from the circuit, drain all
the oil contained within the appliance for any reason,
remove all rubber parts (e.g. O-rings, seals) and send
it to be scrapped.
2.12 ACCESSORIES
The following should be considered as accessories
and are supplied on request:
- Condensate collector tray.
Fig.23
Fig.22
Summary of Contents for - QUAD B-30
Page 153: ......
