31
DIAGRAM FOR GUN
23
connectors on the front of the wire feeder.
(4) Connect the gas line to gas connector on the rear panel of wire feeder.
Check for
Leaks!
(5) Connect the control cable of wire feeder with the aero socket on the rear panel of
welding machine.
(6) Connect the cable of wire feeder with the positive output of welding machine.
(7) Connect the water inlet and outlet pipe of wire feeder with the water inlet and outlet
connectors on the rear front of cooling water.
(8) Connect the control cable of cooling water with the aero socket on the rear panel of
welding machine.
(9) Connect the power cable of welding machine with the output switch in electric box on
site.
NOTE:
Air cooling mode without
cooling device
，
and the water pipe is not needed for
the air cooling mode.
(13) Remove the gas nozzle and contact
tip from the front end of the MIG torch.
(12) Close down the top roller bracket and
clip
the pressure arm into place with a
medium
amount of pressure applied.
(10) Place wire onto spool holder - (spool
retaining nut is left hand thread) Feed the
wire through the inlet guide tube on to the
drive roller.
(11) Feed wire over the drive roller into the
outlet guide tube, push the wire
through
approx 150mm.
10.
Place wire onto spool holder - (spool retaining
nut is left hand thread) Feed the wire through the
inlet guide tube on to the drive roller.
11.
Feed wire over the drive roller into the
outlet guide tube, push the wire through
approx 150mm.
12.
Close down the top roller bracket and clip the
pressure arm into place with a medium amount
of pressure applied.
13.
Remove the gas nozzle and contact tip from
the front end of the MIG torch.
14.
Press and hold the manual wire key to feed the wire down the torch cable through to the torch
head.
Summary of Contents for Evolution MTS500 DP
Page 44: ...44 Notes ...
Page 45: ...45 Notes ...
