19
sigoptics.com
PROGRAMMING SEQUENCE
The sequence of the programming steps has been calibrated to reflect the frequency of potential setting
changes, for example it is more likely that you would change from BEST to LAST target so it is the first
programming step, whereas Unit of Measure (Y or M) is the last programming step as you will likely set
that once and leave it in that setting.
1. BEST or LAST Target
To enter programming mode, press and release the RANGE button to wakeup the rangefinder. After
wakeup, press and hold the MODE button for 2 seconds, then release the MODE button and the
current selection will be flashing (BEST is default). You can toggle between BEST and LAST by pressing
the RANGE button. Your selection will be flashing BEST of LAST. You can confirm your selection by
pressing and releasing the MODE button – which will cause the Target Mode to stop flashing and save
your selection. The rangefinder will then index to the next programming mode which is OLED Display
Brightness. If you do not press and release the MODE button the rangefinder will save your displayed
setting (BEST or LAST) and turn off. BEST Target Mode can be used in most settings, however when
hunting through foliage or in high grass the LAST Target Mode is recommended.
