21
sigoptics.com
you do not press and release the MODE button the rangefinder will save your displayed setting (LOS
or AMR) and turn off. If you choose LOS Mode, the rangefinder will display the Line of Sight range
independent of angle of incline or decline. However, when set to LOS Mode and ranging targets, after the
RANGE button is released, the rangefinder will alternatively display every two (2) seconds for up to ten
(10) seconds, the last LOS range distance acquired and the corresponding angle of incline or decline for
that last distance acquired. The distance value will be shown with the Unit of Measure (Y or M), while the
angle of incline or decline will be a numerical value only. This method is supported for those long range
shooters that need to know both the LOS range and angle, especially when used in combination with a
ballistic drop calculator. If you choose AMR mode, the rangefinder will display only the Angle Modified
Range, as explained elsewhere in this instruction manual.
4. Unit of Measure – Yards (Y) or Meters (M)
After selecting and saving LOS or AMR, the rangefinder will then index to the next programming mode
which is Unit of Measure, Yards (Y) or Meters (M). Your current selection will be flashing (Y is default).
You can toggle between Y and M by pressing the RANGE button. You can confirm your selection by
pressing and releasing the MODE button – which will cause Unit of Measure to stop flashing and confirm
your selection. The rangefinder will then index out of programming mode and is ready to range targets.
If you do not press and release the MODE button the rangefinder will save your displayed setting (Y or M)
and turn off.
