.
39. Glue the two 1/16" sq. strips into position between the two T-5's.
40.
Cut through T-3 at the center line of T-5 on one side.
41.
Remove all ot the pins from the wing parts and rock the spar down onto the plan on one side. This will raise the rest of the
wing from the plan.
42.
Glue the four T-4's and one T-9 into position.
43.
Glue the 1/8" sq. leading edge into position.
44.
Glue T-6, T-7 and T-8 into position.
45.
Glue the two 1/16" sq. strips into position between F-5 and the wing tip.
46.
Remove the wing from the plan and pin the opposite spar to the plan.
47.
Build the opposite side of the top wing as you did the first.
48.
Remove the wing from the building board and glue the eight pieces ot 3/32" x 1/4" balsa to ribs T-5 and T-9.
49.
Sand the wing smooth, round the leading edge and taper the trailing edges.
Building the Landing Gear Spreader
50.
Pin the 3/32" x 3/16" trailing edge to the building board.
51.
Glue parts D-1 ,D-2 a.nd D·3 into position.
52.
Glue the 3/32" sq. leading edge into position.
53.
Glue the three 1/16" sq. strips to the top of the ribs.
54.
Remove from the plan and glue the two 1/16" sq. strips into position on the bottom.
55.
Cut away parts D-2 between the two D-3's.
Cover the Model
56.
Sand the entire model smooth with 400 grit sandpaper.
57.
Cover the top forward fuselage with bond paper. Cut the cockpit from the plan and glue into position on the fuselage.
58.
Coat the exposed surfaces of the model with two coats of clear dope.
59.
Attach the tissue to the model with clear dope mixed 50/50 with thinner.
60.
Lightly mist the model with water to shrink the tissue.
61.
Apply two coats of thinned dope to the entire model.
62.
Cut the Crosses from black tissue and dope into position on the model.
63.
Draw additional details on the model with a waterproof marker and paint the motor detail.
Final Assembly
64.
Assemble the landing gear struts over the plan from 1/16" x 3/16" spruce. Cover and finish with red tissue.
65.
Glue the axle into the bottom of the spreader.
