4
USE AND TESTING:
Make sure the batteries have been installed according to instructions found above.
• If you wish to test your night vision device in a lighted area, be sure the lens cap is in place prior to pressing
the “ON” button. The lens cap has a pinhole opening to admit a small amount of light for testing purposes.
• Move into a dark area before activation the monocular.
• Remove the lens cap from the objective lens. (1).
• Activate the device by pushing the “ON” button (2). The green LED indicator will light up
• If the subject to be viewed is in a completely dark area including lowlight shadow areas, activate the infrared
illuminator (3) by pressing the “IR” Button (4) located next to “ON” button
• Direct the turned on unit at an object at a distance of around 30m. Rotating the eyepiece (5), focus on
the tube’s screen- rough surface or tiny dark dots are visible. Rotate the objective lens (1) until the image
quality is optimal. Re-focus the eyepiece, if necessary. After this adjustment you may not rotate the eyepiece
irrespective of the distance and objective lens.
• Direct your monocular at an object to be view and adjust the final focus by
rotating the objective lens focusing ring until the image is optimal. When
screwing the objective lens into the housing, it focuses on farther objects, when
screwing out - on closer ones.
• When you are finished using your monocular put the cap back on the objective
lens, turn off the unit by pushing the “ON” (2) button (the green LED indicator will
go out) and put it into the carrying case.
CAUTION:
Your monocular can be used in extreme cold. However, when the unit is brought back into a warm environment,
please wait approximately 2-3 hours before using the unit again. Failure to do so may result in damage as a result of
condensation accumulating on the internal circuitry of the unit..
1)
3)
2)
4)
5)
