Copyright © Sigicom AB 2020
5
1.
Introduction
1.1.
Unpacking and Parts Identification
Your C2x Ex Vibration System has been shipped in protective packaging.
Please verify you access to the following list:
•
INFRA C22 Vibration Monitor
•
Flame proof enclosure (incl. 16x M8x30 bolts)
•
4x M10 Mounting bolts and expansion plugs (art.no 1722)
•
1x M6x65 C2x mounting bolt
•
1x M6x150 C2x mounting bolt
•
Silicone grease loctite 8104 75ml
Please report any damage or shortage immediately to Sigicom
2.
Mounting guide
It is always recommended to find a very stiff montage for monitoring
equipment when monitoring vibrations. For this unit extra care needs to be
taken due to its high total mass. Un sufficient mounting will result in
erroneous results. Suitable surfaces are concrete, hard brick or similar. The
unit must not be attached to resilient structures such as corrugated steel
sheet wall covering or weak beams.
The recommended procedure is:
Find or prepare a stiff and flat spot for the mounting, either
horizontal or vertical. Concrete foundation (or similar) is
recommended to provide reliable results.
1.
Set up and start C22 monitoring with preferred settings outside the
enclosure on a flat surface (a table for example). Make sure the
unit is sending data correctly.
For more information about how to
set up the C22 unit, read the C22 manual.
2.
Depending on assembly direction of the unit, the C22 Vibration
Monitor must have correct alignment. See Figure 1 and Figure 2.
