2 SDG7000A Quick Start
easily cause irreparable damage to the equipment. It is necessary to return to the
factory or to the company's designated maintenance organization for maintenance.
Be sure to pull out the power cord before repairing the equipment. Live line
operation is strictly prohibited. The equipment can only be powered on when the
maintenance is completed and the maintenance is confirmed to be successful.
Identification of Normal State of Equipment.
After the equipment is started, there will be no alarm information and error
information at the interface under normal conditions. The curve of the interface will
scan from left to right freely; if there is a button in the scanning process or there is
alarm or error prompt, the device may be in an abnormal state. You need to view
the specific prompt information. You can try to restart the setting. If the fault
information is still in place, do not use it for testing. Contact the manufacturer or the
maintenance department designated by the manufacturer to carry out maintenance
to avoid the wrong test data caused by the use of the fault or endanger the personal
safety.
Do Not Operate with Suspected Failures.
If you suspect that there is damage to the instrument, please let only qualified
service personnel check it.
Avoid Exposed Circuits, Wire, or Components.
Do not touch exposed contacts or components when the power is on.
Do not operate in wet/damp conditions.
Do not operate in an explosive atmosphere.
Keep the surface of the instrument clean and dry.
Only lithium batteries with the same specification could be used to replace
the battery on the main board.
The responsible body or operator should refer to the instruction manual to
Summary of Contents for SDG7000A Series
Page 1: ...SDG7000A Arbitrary Waveform Generator EN01A Quick Start...
Page 2: ......
